Masturbation techniques
Not getting enough of new positions, variations and techniques? Well, you can rest assured because we’ve found another couple of techniques for you to try out. Playful exploration is one of the best parts of sex and we’re doing our best to keep you happy. So, here are the new techniques that you can try when nobody’s around.
Many men enjoy the feeling of something cold placed against the hot skin of the penis. Since sticking the penis in a fridge is impractical, we recommend the use of ice cubes or crushed ice to increase the strength of orgasms. Here’s how it works.
Masturbate the way you usually do using your preferred technique and keep a few ice cubes or a bag of crushed ice handy. When you feel the climax building pick up the ice cubes and place them against your testicles or rub them over your penis, if you can manage that without getting in the way. Trust us, the feeling is quite unique.
The first one is a bit tricky to pull off. Lie on your back with your erect penis straight up in the air. Wrap the fingers of one hand around the base of the penis and start stroking yourself with a quick, circular motion.
Make sure the strokes are always short. The stroking speed must vary in order to get the glans to jerk around in a circular motion, the reverse of that of your hand. Be careful: ejaculation can be very messy due to sperm flying all over the place.
Or you could try a technique devised by people with lots and lots of time on their hands, the connoisseurs of the masturbation world. The basic idea is to bring yourself to a good, strong orgasm by tapping gently on the glans, through the underwear. The orgasm will be slow coming, but the sensation is bound to be much stronger than usual.
If you enjoy masturbating in the bath and using hot water then you simply have to try the steam bath. Get naked and into the bathroom and turn on the hot water tap.
Let the water flow for a couple of minutes in order to turn the room into a regular sauna. When everything in the bathroom is hot and steamy, get into the tub (mind the hot water!) and start masturbating, using the heat and steam as lubricant. The sensation is quite unique and very pleasant.
A good way to heighten orgasm is to put a little pressure on your testicles. During masturbation, reach down and start caressing and squeezing your testicles.
Make sure you don’t press too hard on them, even though it may seem to you that you can stand it. During the orgasm, you will feel the semen moving up from the testicles as the scrotum contracts. the experience will certainly be an intense one.
Join our newsletter and receive free sex tips in your inbox. You will also get free copy of 101 Romantic Ideas E-Book.
Here’s a tip:
http://opensourcevagina.blogspot.com/
OpenSource Vagina: A Lubricant-Free, Mess-Free Design for Human Males
(Version 1.0.20070609)
The priorities of this project were, in order:
* Simulating the sensation of a vagina without the use of fluid lubricants (fluids require too much cleanup, and cause fermentation issues)
* Ease and speed of cleanup, reloading, and general maintenance
* Mess containment
* Simplicity and economy of construction
* One size fits almost all
* Minimal size
What were not priorities:
* Simulating the appearance of a vagina.
Materials:
* 9″ length of 2″ diameter PVC tubing
* Slip cap for 2″ diameter PVC tubing
* 2 x 6″x12″ slippery smooth flat nylon fabric
* 14″ of 4″ width elastic ACE Bandage (NOT self-sticking variety)
* 4 safety pins
* Rubber band
Tools:
* Hand saw
* Ruler
* Sandpaper
Construction:
* Saw two parallel 5″ slits opposite each other on one end of the tubing. Use sandpaper to remove all rough edges.
Setup:
* Cut the 14″ length of elastic bandage in half (so you have two 7″ pieces)
* Fold one of the above 7″ pieces in half, make in to a tube by safety-pinning top and bottom together anywhere between 2.5″ and 3″ from fold, depending on how tight you want it to feel
* Repeat above step for other 7″ piece
* Slide a portion of each of the elastic bandage tubes it’s full length (4″) down the slit, on opposite sides from each other. The remaining portion of each elastic tube will naturally go around its half of the outside of the PVC tube
* Fold to double-thickness each of the 12″ slippery nylon fabrics, then slide the folded ends 4.5″ down the two slits BETWEEN the elastic bandages
* At the opening of the Artificial Vagina, pull the excess nylon fabric over to their respective sides (to get them out of the way). A rubber-band around the PVC tubing should keep the fabric from flopping around
* Check (with your fingers or any broomstick like appendage) that there really is a clear path straight-through the vagina and all the way down through the PVC tubing
* Fill the slip cap with toilet paper, and slide it gently on the far end of the tube
* Done!
Maintenance:
* After use, prop the tube upright on the slip cap to allow drainage to the tissue. In a few minutes, take off the slip-cap, throw away the tissue, and either let it dry or just reload the cap with tissue for immediate reuse.
Tips:
* It can greatly enhance sensation to put a thin spongy or fluffy material in the space between the elastic bandage and the inside of the PVC tube. This is because adds a compression squeeze to the tension squeeze afforded by the the bandage. Try it first on only one side
* Consider making two or three Artificial Vaginas to have ready in case one requires drying-out time
* Baby powder or corn starch can reduce friction in the artificial vagina
* Try different fabrics for sensation. Teflon, for instance, might be ideal in moisture repellance and friction. The main issues is how they deal with moisture; nylon tends to get a very high friction component when wet, ruining sensation. ALWAYS be sure to avoid toxic materials
* Try coatings for the fabric, spray-on (like silicon spray), powder (graphite), or soaked (hair conditioners). ALWAYS be sure to avoid toxic materials
Leave your response!